Thumper Fab Rear Bolt-On Chassis Stiffener

[AVI8OR]

Finally got this installed today. Not very difficult to install once I figured out exactly how each part goes. The directions provided are ok however could have been more clear with parts provided and their orientation. Definitely more beefed up now!

 

[oneal]

I was looking at those couple weeks ago. I wondered if there was a weakness in that area I wasn't aware of ?
Like all TF items looks good

 

[Mr.C]

I was looking at those a couple weeks back on their website. Looks like they have a front one now as well. I installed Super ATV’s front one on my old XP 1000.

How difficult was the install?

 

[AVI8OR]

I ordered the front one too, hasn't shipped yet unfortunately. The rear install wasn't too bad. Took roughly 1.5 hours only because the directions could have been more clear. The pictures aren't the best and don't depict very clearly which orientation the parts go. Once I figured it out the install was straight forward. TF claims the lower control arm attachment points on our rigs is a weak point. I can see this being potentially true, especially for those who run the machines hard. After the install, the areas are definitely more sturdy now.

 

[Mr.C]

Thanks, TF is never fast with getting their parts out the door seems like. I’ll probably be ordering both of these as well.

 

[AVI8OR]

Thanks, TF is never fast with getting their parts out the door seems like. I’ll probably be ordering both of these as well.

No they are not. Great products just slow as hell shipping. I'll post the front install once I receive it from TF and have it installed.